Clean It Up
UK Window Cleaning Forum => Window Cleaning Forum => Topic started by: andy east sussex on June 07, 2010, 04:21:08 pm
-
i need a valve on the waste pipe wot valve do i use or can i use ???
-
dont have one like mine as it can be very difficult to ajust sometimes
(http://i272.photobucket.com/albums/jj186/zwizard1/utf-8BSU1HMDAwNTEtMjAxMDA1MjYtMjAzN.jpg)
Andy
-
why is it hard to adjust sometimes ? and what is it wot u used any idea what i can use
-
use some half inch pipe with a valve tap that you use with your 8mm pipe on the reel
-
its hard to ajust the flow rate
I try and get a 50 /50 balance waste and pure
not the best i would go with one like this
(http://i272.photobucket.com/albums/jj186/zwizard1/utf-8BSU1HMDAwNzEtMjAxMDA2MDctMTYzO.jpg)
I should change mine , just not got round to it yet :'(
-
i go for a 60 % waste and 40% pure that tap looks a bit big but probaly would do the job but you could get a smaller one
-
how do u fit that on to hose surely hose wud blow out of that
-
I use one of these. About £4 from B&Q
-
you would need to play around with the fittings a little , and get a hoselock end to connect your hose to it
Andy
-
right superb i have just recived new 4040 housing guess what it has a bloody membrane already :):):) but trouble is it has 2 holes at both end with push fit how do i connect pipes to it its the stainless steel housing im so bloody confused
-
any idea of what to do ?
-
If remember correctly think its the middle hole you connect to on the stainless steel. will look at mine later
-
ye thats right but i have 2 waste holes as well what the hell lol ????????????
-
yeah think thats the middle one as well one second will have a look
-
right on the water input the middle hole gets blanked off.
on the pure and waste side middle is pure and the other is waste with your tap on.
if that makes sence?
-
in from tap must go on to middle one and on exit end the middle is pure and the one right beside it is waste but i also have a waste on the inlet end as well
-
yeah as i said the hole on the inlet gets blanked off ::)
the inlet is not the middle one its the outter one! nearest the edge! i checked on mine.
if you read my above post ive just told u what to do
-
thank you
-
so i blank off the middle one on the inlet ?
-
yes with a blanking plug