Clean It Up

UK Floor Cleaning Forum => Carpet Cleaning Forum => Topic started by: Dub on January 25, 2009, 09:34:48 pm

Title: Upholstery Tool
Post by: Dub on January 25, 2009, 09:34:48 pm

Hi does anybody know what size tread the hose on the detail tool takes. I know the quick release end  is 1/4" but looking for the valve size, or someone that sells them. :-*

same as Image below
http://www.rotovacusa.com/images/westpak_SG_Detail_Tool.jpg

Title: Re: Upholstery Tool
Post by: John Kelly on January 25, 2009, 10:04:06 pm

1/4 inch.

Title: Re: Upholstery Tool
Post by: Mike Halliday on January 25, 2009, 10:19:05 pm

the thread that screws into the valve of the handtool is smaller than the thread on the QR at the oppisite end (but  its the same on a wand valve)

If bud is correct that the QR is 1/4" then the valve must be smaller

this picture might show the difference

Title: Re: Upholstery Tool
Post by: John Kelly on January 26, 2009, 10:44:35 am

Sorry, 1/4" connect side, 1/8" at valve side.

Title: Re: Upholstery Tool
Post by: tony harrison on January 27, 2009, 09:12:06 am

Mike,

That valve which is on the QR coupling looks interesting ( small ) where do you get them from ?.

Regards Tony.

Title: Re: Upholstery Tool
Post by: Dub on January 29, 2009, 05:50:52 pm

( Thanks  all ) ???   1/8  NPT  it shall be ...