Clean It Up
UK Window Cleaning Forum => Window Cleaning Forum => Topic started by: Bungle on January 16, 2021, 05:04:57 pm
-
On my SLX-22 that wears out first. You'd think section #1 would wear out first? This has happened on my last 3 SLX-22 poles. You know when they're on their way out because you can hear the pole making a cracking noise. I had one snap behind railings on an upstairs window once. Fun and games getting that back 🤪
-
Spraying a good covering of clear lacquer on that particular section can make them last longer I also try to not keep extending to same part of that section for days at a time,it’s like the red bands on the poles I never keep going all the way down to these or as you say they’ll start to wear quicker.
-
On my SLX-22 that wears out first. You'd think section #1 would wear out first? This has happened on my last 3 SLX-22 poles. You know when they're on their way out because you can hear the pole making a cracking noise. I had one snap behind railings on an upstairs window once. Fun and games getting that back 🤪
I use the 22 as well, I've never had a section 4 go its always the top 2 that go for me.
-
On my SLX-22 that wears out first. You'd think section #1 would wear out first? This has happened on my last 3 SLX-22 poles. You know when they're on their way out because you can hear the pole making a cracking noise. I had one snap behind railings on an upstairs window once. Fun and games getting that back 🤪
I've never worn out a section 4 or 5 on any pole I've owned in 10 years....its always the top 3 sections that wear and splinter from my experience....
-
On my Xtreme 22, it's section #3 that goes first because I always have to extend it partially, so it wears inside and out like section #2, but there's more leverage on that section.
On my Xtreme 25, it's section #2, as I seldom use the other sections. Section #1 an #3 only wear on one side, the outside and inside respectively.
The other sections are only likely to break first due to accidents.
-
I have a 22 Xtreme and it's lasted for bludy years!
Recently it's been cracking like a David Attenborough series about icebergs!
I use WD40 and Two part, rapid setting, Araldite.
So far so good.
;D
-
I use a SLX18, and this one (3mths use), its section 3 that always grits up first, which is strange as its always normally the top sections downwards that grit up first? Ive had to remove the stop tape on this section 3 to help stop it gritting up as fast. I was having to flush it every few jobs or so.