Clean It Up

UK Floor Cleaning Forum => Carpet Cleaning Forum => Topic started by: heritagecleaning on June 06, 2023, 09:03:43 pm

Title: Wonderwand jet issue (maybe?)
Post by: heritagecleaning on June 06, 2023, 09:03:43 pm

https://youtu.be/GQUJhkgyNj4 (https://youtu.be/GQUJhkgyNj4)

Looking at this you would think the jets were blocked and this was causing the backfire, but I soaked them in Viakal overnight and I can see daylight when I hold them up to the light and look through them.

All I can think of is to fit the rubber nozzle seal / o rings, but I've never used them before and things have always been fine.

I'm stumped! Any ideas?

Cheers, Owen.

Title: Re: Wonderwand jet issue (maybe?)
Post by: Nigel Davies on June 06, 2023, 10:52:26 pm

Yes, you're right - it's the Nozzle O rings that need replacing.

Title: Re: Wonderwand jet issue (maybe?)
Post by: heritagecleaning on June 07, 2023, 11:55:03 am

Will give it a go, thanks.  :)

Title: Re: Wonderwand jet issue (maybe?)
Post by: Cleanevangelist on June 12, 2023, 09:39:49 am

Hi

The o ring need replace so often that you need to use a hack to get around the cost. buy new ones then use plumbers tape around them. after i did this never had to buy o rings again.

Ian Harper

Title: Re: Wonderwand jet issue (maybe?)
Post by: AJB on June 20, 2023, 08:49:31 am

I've only ever bought 3 seals for mine in 14 years, and 2 of them are still in the packet.