Working in ice/snow
« on: November 22, 2010, 07:22:25 pm »
This is my first winter window cleaning. I was wondering if its possible to work in ice or snow. I have grit ready to use where needed. Or is it best to stay at home?

Re: Working in ice/snow
« Reply #1 on: November 22, 2010, 07:26:18 pm »
i my self would stay at home, as better too lose a few days wage rether then get sued becasue some old lady slips

Crystal-clear

  • Posts: 3029
Re: Working in ice/snow
« Reply #2 on: November 22, 2010, 07:31:17 pm »
Stay at home its not worth it iced roads is to dangerous personally i wont work in those conditions and on days that are below 0 i wouldnt work too once it creeps up to 1 or 2 thats fine thou.

G Griffin

  • Posts: 40745
Re: Working in ice/snow
« Reply #3 on: November 22, 2010, 07:34:01 pm »
i my self would stay at home, as better too lose a few days wage rether then get sued becasue i wear old lady slips

Each to their own.
⭐⭐⭐⭐⭐⭐

dazmond

  • Posts: 23586
Re: Working in ice/snow
« Reply #4 on: November 22, 2010, 07:36:02 pm »
yes you can work in ice and snow.i did a few half days during last winter.usually started about 11am and finished around 3 pm.NO ladders,NO WFP!just my trad pole/bucket with screenwash and squeegees!



dazmond
price higher/work harder!

Dave Anderson

  • Posts: 787
Re: Working in ice/snow
« Reply #5 on: November 22, 2010, 08:21:38 pm »
I do work in some ice and snow but I have found it dangerous to get to the work with a weighted vech alot of the time.

The more I know the less I know I know ...

Re: Working in ice/snow
« Reply #6 on: November 22, 2010, 08:27:35 pm »
i my self would stay at home, as better too lose a few days wage rether then get sued becasue i wear old lady slips

Each to their own.

 ;D

tompoole

  • Posts: 800
Re: Working in ice/snow
« Reply #7 on: November 23, 2010, 08:13:18 am »
Screen wash , van heater, work when ground temp is above
Freezing, you'll be ok. I go out as much as poss just to keep
The money ticking over. I have a Landrover so end up towing
People up hills and out of ditches;-)
Happy days
Ps don't want to put a damper on it but we are expecting it
To be cold on and off until march so get used to working in it
But be safe. Get out every opportunity , last year people took
A week of between Xmas and new year , because it snowed
Before Xmas and after new year , some people didn't work for
4/5 weeks

formb

Re: Working in ice/snow
« Reply #8 on: November 23, 2010, 09:58:31 am »
Screen wash , van heater, work when ground temp is above
Freezing, you'll be ok. I go out as much as poss just to keep
The money ticking over. I have a Landrover so end up towing
People up hills and out of ditches;-)
Happy days
Ps don't want to put a damper on it but we are expecting it
To be cold on and off until march so get used to working in it
But be safe. Get out every opportunity , last year people took
A week of between Xmas and new year , because it snowed
Before Xmas and after new year , some people didn't work for
4/5 weeks

 ;D


Do you use it for WC?

cozy

Re: Working in ice/snow
« Reply #9 on: November 23, 2010, 10:33:08 am »
yes you can work in ice and snow.i did a few half days during last winter.usually started about 11am and finished around 3 pm.NO ladders,NO WFP!just my trad pole/bucket with screenwash and squeegees!



dazmond

same here.

ant french

Re: Working in ice/snow
« Reply #10 on: November 23, 2010, 10:37:10 am »
anything below 3 in the day i wont work in  ;D  not that i dont wanna its my body wont let me and i suffer at bed time :-[ :-[

tompoole

  • Posts: 800
Re: Working in ice/snow
« Reply #11 on: November 23, 2010, 02:29:24 pm »
Yes the Landrover is the work truck

Paul Coleman

Re: Working in ice/snow
« Reply #12 on: November 23, 2010, 04:06:39 pm »
I did work when there was snow and ice on the floor last year but I couldn't get out from 2nd - 10th January.  The air temperature was below zero all day during those days and I didn't see the point of trying to squirt water onto glass for it to freeze a few seconds later.  As soon as it drifted even a little above zero, I was back out there though.  I ran my hose around piles of snow and had a liberal quantity of rock salt with me for the vulnerable areas.  For the very vulnerable areas, I tradded the ground floor to reduce the amount of water lying around.  It was slow and painstaking but I still managed to get to three figures in a day - quite an achievement considering what I was up against.  Also, I had to select my work carefully and avoid hilly areas in some cases.

zimzam

  • Posts: 192
Re: Working in ice/snow
« Reply #13 on: November 23, 2010, 04:35:40 pm »
yes you can work in ice and snow.i did a few half days during last winter.usually started about 11am and finished around 3 pm.NO ladders,NO WFP!just my trad pole/bucket with screenwash and squeegees!
dazmond

same here.

never used screenwash. :-\ what quantity do you put in the bucket?

formb

Re: Working in ice/snow
« Reply #14 on: November 23, 2010, 05:14:50 pm »

tompoole

  • Posts: 800
Re: Working in ice/snow
« Reply #15 on: November 23, 2010, 05:40:16 pm »
300 tdi 110 commercial and
300 tdi 110 county station wagon
I sold the commercial, I was looking to expand but just got
Time wasters and dole boys so sold one truck

formb

Re: Working in ice/snow
« Reply #16 on: November 23, 2010, 06:39:20 pm »
300 tdi 110 commercial and
300 tdi 110 county station wagon
I sold the commercial, I was looking to expand but just got
Time wasters and dole boys so sold one truck

We run 110s are you wfp?

tompoole

  • Posts: 800
Re: Working in ice/snow
« Reply #17 on: November 23, 2010, 09:19:31 pm »
Yes wfp, diy system. The truck doubles as a camping palace
In the summer

formb

Re: Working in ice/snow
« Reply #18 on: November 23, 2010, 11:13:31 pm »
Yes wfp, diy system. The truck doubles as a camping palace
In the summer

Nice.

Do you have fitted tanks?

We have custom 750l tanks, there are 6 125l tanks that fix together then bolt down to the chassis. They are reasonably priced.

♠Winp®oClean♠

  • Posts: 4085
Re: Working in ice/snow
« Reply #19 on: November 23, 2010, 11:18:48 pm »