Clean It Up

UK General Cleaning Forum => General Cleaning Forum => Topic started by: *Derek* on December 10, 2019, 12:04:51 pm

Title: Flat surface cleaner
Post by: *Derek* on December 10, 2019, 12:04:51 pm

One of my fsc’s is leaving lines, what is cause of this? I’m guessing wrong nozzles?

Title: Re: Flat surface cleaner
Post by: Mike Halliday on December 10, 2019, 01:13:34 pm

Has it always done it are just started? Have you recently changed the jets?

It might be that you are going too fast across the ground

Title: Re: Flat surface cleaner
Post by: Splash & dash on December 10, 2019, 08:08:28 pm

Dirt or rust in the nozzles or badly worn nozzles can cause this

Title: Re: Flat surface cleaner
Post by: *Derek* on December 11, 2019, 07:20:46 pm

Pretty much always done this.

Title: Re: Flat surface cleaner
Post by: Roland S on December 16, 2019, 04:12:17 pm

depending on what you're cleaning it could be that where you're overlapping the cleaning, a small section is obviously getting cleaned twice and is just cleaner, if that's the case maybe you're going a bit too fast.