Clean It Up
UK Floor Cleaning Forum => Hard Floor Cleaning Forum => Topic started by: gwrightson on March 30, 2017, 08:06:35 pm
-
I have a Honda pressure washer , recently serviced but recently found when first using the lance the pressure is not so good, but after a couple of minutes the pressure increases and works fine, any suggestions?
I was thinking along the lines of uploader valve, but if I am honest I havnt a clue
Geoff
-
had similar problem with mine take a look at spinaclean videos they go through all potential problems
mine problem intake of air in pipe fairly simply fix made hell of a difference. best of luck
-
Thank you Scott
Geoff
-
Air leak, pistons, pumps seals or UNloader of say without seeing it. What's engine, pump and unloaded does it have one it? Is it gravity fed?
-
Hi Neil,
It is not gravity fed,
I have recently had all seals done and pistons.
I have checked for air leaks, seams strange one to me, I used yesterday pressure was very low initially, so low it didn't even spin the nozzle then after a couple of minutes the pressure was as good as it ever been.
Geoff