Clean It Up
UK General Cleaning Forum => General Cleaning Forum => Topic started by: *Derek* on December 10, 2019, 12:04:51 pm
-
One of my fsc’s is leaving lines, what is cause of this? I’m guessing wrong nozzles?
-
Has it always done it are just started? Have you recently changed the jets?
It might be that you are going too fast across the ground
-
Dirt or rust in the nozzles or badly worn nozzles can cause this
-
Pretty much always done this.
-
depending on what you're cleaning it could be that where you're overlapping the cleaning, a small section is obviously getting cleaned twice and is just cleaner, if that's the case maybe you're going a bit too fast.