Clean It Up
UK General Cleaning Forum => General Cleaning Forum => Topic started by: ukmediums on November 19, 2003, 11:18:52 pm
-
I am now using the buffing machine with a bit more ease than at first, however when I use the red pads they get realy caked up with dirt to the point they are shiny when I remove them from the machine.
Is there a good way of cleaning them, are they machine washable??? I have soaked them but they shinyness remains.
As always your help is appreciated
Simon
-
Hello Simon
If your red pad is being clogged with dirt, try using a green pad and mop the floor with cold water and cheap washing up liquid (less salt in the cheap stuff) scrub the floor while wet with the green pad, then mop up all the residue. Mop again with clean water and Leave to dry and then buff with a red pad. If you are using floor maintainer (pink) only use 30ml per 0.5 litre hand spray. And use very sparingly if the red pad becomes clogged when the floor has been cold water scrubbed with a green pad, it usually means you are using too much maintainer.
I usually clean my pads with a stiff loo brush under cold running water, and then leave to dry.
You can machine wash them, it depends on the quality of the pads you are using. 3M pads stand up well to being machine washed (40 degrees) but cheaper pads tend to fall to bits
Hope this helps
Russ
www.deep-clean.co.uk
-
You can use a pressure washer to clean the pads too, Of course you can only do this outdoors.
-
A little tip I got from some school caretakers on my site is when you get a pad (whatever colour) it comes with a little center disk that you normally have to poke out.
I'm told that the center bit is ideal after using to scrap any build-up on the main pad during use or before you store it away after use.
School Caretakers also use it to remove stubbon marks on floors by hand while buffing.